Keep cables out of walkways and away from site roads first: route them overhead, around the traffic, or remove them with cordless tools. HSE asks for cables at high level, especially along corridors. Where a cable must cross a road or access way used by vehicles and plant, BS 7671 requires adequate mechanical protection, which on most sites means a cable protector rated for the traffic.
STAT
30% of specified non-fatal injuries to construction employees came from slips, trips or falls on the same level, in RIDDOR reports averaged over 2022/23 to 2024/25. HSE published the figure on 20 November 2025. Source: HSE, Construction statistics in Great Britain, 2025
Key takeaways
| Topic | In brief |
|---|---|
| First choice | No cable on the floor: cordless tools, overhead routes, routes around traffic. |
| Walkways | HSE wants cables at high level, especially along corridors. |
| Site roads | Avoid crossings. Where one is unavoidable, protect the cable mechanically. |
| Cable type | Flexible cables that move on site: H07RN-F or equivalent. |
| Protector | Rated for the heaviest vehicle that crosses, fixed and visible. |
Why do cables on the floor matter on a site?
Because trips are one of the biggest injury sources in construction. HSE’s statistics published in November 2025 put slips, trips or falls on the same level at 30% of specified injuries to construction employees and 22% of injuries that kept a worker off for more than seven days, averaged over three reporting years. Only falls from height caused more specified injuries.
HSE’s guidance page on slips and trips says several thousand construction workers are injured in this way each year, and around 1000 of those injuries involve broken bones or dislocated joints. It also says most could be avoided by managing working areas and access routes well.
A cable on the floor is two problems at once. It is a trip hazard for people, and it is a cable that wheels, pallets and dropped materials can crush. Damage to the sheath of a live flexible cable is an electrical risk, not only a tidiness issue.
What does HSE ask for on walkways and corridors?
HSE’s construction guidance starts by removing the cable. If you can use cordless tools, it notes, you may not need cables at all. Battery tools and, for heavier loads indoors, a battery power station take leads out of the walkway; our post on battery power stations on site covers what they can run.
Where cables are needed for temporary lighting or mains-powered tools, HSE says to run them at high level, especially along corridors. Hooks, cable hangers and the structure itself keep the lead above head height and out of the way of trolleys.
HSE also describes what a good walkway looks like: clearly designated, with good conditions underfoot, signposted and adequately lit. A cable lying across that route undoes all four.
What does BS 7671 say about cables across site roads?
The wiring regulations treat construction sites as a special location in Section 704. As NICEIC summarised it in May 2023, regulation 704.522.8.101 says cables should not be installed across site roadways or access ways used for transport and mobile plant. Where that is unavoidable, adequate mechanical protection has to be provided against damage from vehicles and the movement of building materials.
The same regulation sets the cable type: flexible cables subject to movement on construction sites are H07RN-F or equivalent. That is a heavy-duty rubber-sheathed cable, but it is still not designed to be driven over unprotected.
The order matters. A protector is the answer to an unavoidable crossing, not a licence to run every lead across the haul road.
Routes compared
| Route | When it suits | Watch for |
|---|---|---|
| Cordless, no cable | Hand tools, short tasks | Charging point and battery capacity |
| High level along the structure | Corridors, stairs, temporary lighting | Secure fixing, clear of moving loads |
| Around the traffic | Open sites with space for a longer route | Voltage drop on the longer lead |
| Buried or ducted crossing | Long-term crossings of a haul road | Marking the route, planning before groundworks finish |
| Cable protector on the surface | Unavoidable short-term crossings | Load rating, fixing, visibility |
A longer route has its own cost. The extra length adds voltage drop, which our guide to how long a site extension lead can be works through.
How do you choose a cable protector?
Start from what crosses. A protector that suits pedestrians and hand trolleys is not the same product as one that carries a telehandler or a delivery lorry. Manufacturers rate their protectors for a load and state the conditions of that rating, so read the product sheet against the heaviest vehicle that will use the crossing.
Then check the fit. The channels must take the cables you have without squeezing them, and each cable should sit in its own channel where the protector allows it. A lid that does not close over the cable gives the wheel a point load on the sheath.
Finally, think about the people. Ramps with a gentle slope are easier to walk and wheel over than a raised lump, and a high-visibility top makes the crossing visible in winter darkness. The protector also becomes part of the walkway, so its surface needs the same good conditions underfoot that HSE asks for.
TSR stocks the GAARD RAMP cable cover, a recycled rubber protector of 800 x 500 x 70 mm with four 50 x 50 mm channels. Its product page, read in November 2026, gives a load capacity of 60 000 kg and says even a full trailer truck can drive over it. One unit takes up to four cables or hoses, and units connect in series for a wider road. TSR adds two rules: place the cables in the channels before traffic starts, and make sure no cable is pinched between the channel edge and the ground.
Crossing check before power goes on
- Remove first. Can cordless tools or a battery source replace the lead?
- Lift it. Corridors and stairs: cables at high level, fixed to the structure.
- Reroute. Can the cable go around the road or walkway instead?
- Protect. Unavoidable crossing: a protector rated for the heaviest vehicle.
- Fit. Each cable in a channel, lid closed, ends secured.
- Mark. Make the crossing visible and keep it lit.
- Inspect. Check the protector and the cable sheath as part of the daily check.
Connectors that lie outdoors along the route need a suitable rating as well; our post on IP ratings for site electrical equipment explains IP44, IP67 and the rest.
Summary
The best cable crossing is the one you do not need. Take tools cordless where you can, run leads at high level along corridors as HSE asks, and route around traffic. Where a cable has to cross a road or access way, BS 7671 requires adequate mechanical protection: a protector rated for the heaviest vehicle, with the cable seated in its channel and the crossing marked. Tell TSR what crosses your site and how many cables need to pass, and we will propose the protection that fits.
Frequently asked questions (FAQ)
Can site cables lie across a walkway?
Avoid it. HSE’s construction guidance asks for cables for temporary lighting and mains tools to run at high level, especially along corridors, and for walkways to have good conditions underfoot.
Are cable protectors required on construction sites?
Where a cable must cross a site road or access way used by vehicles and plant, BS 7671 regulation 704.522.8.101 requires adequate mechanical protection. A rated cable protector is the usual way to provide it on the surface.
What cable type should be used for flexible leads on site?
BS 7671 Section 704 calls for H07RN-F or equivalent for flexible cables subject to movement on construction sites, as NICEIC summarised in May 2023.
How do I know a protector can take a vehicle?
Read the manufacturer’s load rating and the conditions it was given for, and compare them with the heaviest vehicle that will cross. Pedestrian ramps and vehicle-rated protectors are different products.
Is it better to run cables overhead or under a protector?
Overhead or around the traffic first, because nothing then lies on the ground. A protector is for crossings that cannot be avoided.
How often should a crossing be checked?
As part of the daily site check: the protector in place and closed, the cable undamaged where it enters and leaves, and the crossing still visible.
Sources
- HSE, Construction statistics in Great Britain, 2025 (published November 2025)
- HSE, Slips and trips in construction
- NICEIC via Voltimum, Environmental factors on construction sites (May 2023)
- TSR-Elsite, GAARD RAMP cable cover 4-channels
TSR-Elsite. Published 16.11.2026.