The Mounting plate 95-240 is a fixing plate for connectors in modular distribution boards. You use it together with 95-240 mm² connectors, and you need one plate per connector.

Add the product to the quotation basket and send your request – we confirm availability and delivery time at the same time.

Mounting plate 95-240 – features

• Fixing plate for connectors in modular distribution boards
• For 95-240 mm² cable lug connectors
• One mounting plate per connector
• Holds the connector in place at the correct distance from the busbar
• Mounts on the front panel of the board at the module slot

Where the Mounting plate 95-240 is used

The plate suits modular board installations that use 95-240 mm² cable lug connectors. It works as the base of the connector.

In practice, the plate holds the connector in place and at the right distance from the busbar. Without it, the connector does not sit correctly in the board.

You need one plate for each connector. Therefore, size the number of plates by the number of connectors.

Always choose the plate by connector size. If you order the connector and the plate separately, check that they are the same size class. Otherwise the installation stops on site.

Part of a modular distribution board

Modules attach to the rail system of the board. As a result, you can change the configuration as the site progresses, without rewiring.

The foundation phase needs different power than the interior phase. Therefore, you swap modules instead of buying a new board. In a rental fleet, the same frame also moves from site to site.

See the full range of modular distribution boards and modules. Ready boards with plug supply are in the plug-on sub-distribution boards group.

Mounting plate 95-240 – installation and maintenance

A qualified electrician carries out the installation and any changes. First, make the board dead before you add or replace modules, and verify this by measurement.

The plate goes on the front panel of the board at the module slot. Do not leave unused module slots open, because live parts would then be within reach.

A poor joint does not show from the outside. However, it heats up under load, and the heat damages first the insulation and then the busbar.

Check the joint after the first day under load and regularly after that. An aluminium conductor needs more frequent checks than copper, because aluminium creeps under tightening.

Safety

Site electrical installations must meet the same requirements as fixed ones, and some are stricter. For this reason, inspect the board at commissioning and regularly during use.

The inspection covers the enclosure, the joints and the protective devices. It also confirms that nobody can reach live parts.

Do not repair a damaged part on site. Instead, replace a burnt connector or a cracked enclosure, because a temporary repair on site almost always becomes permanent.

The requirements for electrical work are explained on the Tukes website.

Mounting plate 95-240 – technical data

Application	95-240 mm² connectors
Requirement	1 mounting plate per connector
Mounting	Front panel of the board, at the module slot

Frequently asked questions

Which connectors does the plate fit?

It fits 95-240 mm² cable lug connectors.

How many plates do I need?

You need one mounting plate for each connector.

Is the plate included with the connector?

Some connectors include the plate, while others need it separately. The product name tells you, and we also confirm it in the quotation.

Who may install the plate?

A qualified electrician does the installation. The requirements are explained on the Tukes website.

Request a quote

Add the product to the quotation basket and send your request – we confirm availability and delivery time at the same time.

Tell us the number and size of your connectors. We then list the right plates and connectors in one quotation.